LABVIEW TEKTRONIX OSCILLOSCOPE DRIVER DOWNLOAD


This site uses cookies to offer you a better browsing experience. In this case, you will use a regular straight-through twisted-pair Ethernet cable to connect each device to the hub. This document describes how to set up a computer and Ethernet-based instrument to communicate over a simple Ethernet cross-over cable. Sign up or log in Sign up using Google. Email Required, but never shown. For Ethernet, pairs 1 and 2, and 3 and 6 are used.

Uploader: JoJogul
Date Added: 8 July 2011
File Size: 7.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 51967
Price: Free* [*Free Regsitration Required]

A crossover cable is an RJ cable which lets you plug the two network ports together directly without needing a network hub.

Press OK on all of these dialogs and return back to Windows. For those who may have this question, I do have found a way around.

This should bring up the window below.

LabVIEW Add-On for Tektronix Open Windows Oscilloscopes Version 1.2

In this case, you will use a regular straight-through twisted-pair Ethernet cable to connect each device to the hub. Learn more about our privacy oscilloscpe.

This site uses cookies to offer you a better browsing experience. Yes, but you must use a hub in this case. Configuring Oscilloscope timebase from labview Ask Question. You should then see a dialog that looks like the image below.

  MCP51M LAN DRIVER

On the computer, navigate to http: In above calculation, just make sure you do not cross your sampling rate provided by vendor.

Sign up or log in Sign up using Google. Ashutosh 1 4 Testing Now we need to verify that we configured everything correctly and that our cable is working okay.

Can I use a standalone hub instead? Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies. Be sure that the IP address and Subnet mask match the numbers shown above.

LabVIEW Add-On for Tektronix Open Windows Oscilloscopes Version – National Instruments

A cross-over cable maps the 1,2 ttektronix on each end to 3,6 on the other end. Back to Top 4. First, you need to get to the network configuration control panel.

These are 8-wire connectors slightly larger than RJ modular phone jacks. This should bring up a page that looks something like this.

By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service.

  IP2500 CANON DRIVER DOWNLOAD

Press OK Accept to apply the changes.

In this dialog, we want to turn off Obtain an IP address automaticallyand switch it to Use the following IP address. Can I connect three or more devices together? By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

Everything else is the same. Rate this document Select a Rating 1 – Poor 2 3 4 5 – Excellent. How do I make a cross-over Ethernet cable?

For Ethernet, pairs 1 and 2, and 3 and 6 are used. Back to Top 2. In the NI driver for scope to set the timebase “Configure Timebase.

Tektronix TBS1062

Stack Overflow works best with JavaScript enabled. Now we need to verify that we configured everything correctly and that our cable is working okay. Sign up using Email and Password.